In that way, I hope I can contribute to the pool of knowledge. This could be caused by a blockage within the shower head or hose. I was just hoping that someone would miraculously pipe up with ‘hey I know exactly what that is, i fixed the same problem last week’ Haha. But, I followed the instructions in this thread and my shower now works. To replace a digital pumped outlet with a standard outlet, you will need to isolate the water and the power to the shower and remove the pumped processor unit. Installed supplies to a few but never had to fault find on one. It now seems that I was too optimistic.
The water system that the property is on, size of the pipe work leading up to the shower connections and also if any other outlets are used within the property at the same time as the shower.
View all Shower Spares Parts. Once again, t ants. I might learn a thing or two. Choose your Shower Hose. Flow stops after 10 secs. Unplug the four connectors at the bottom of the Logic Module.
I cannot contact aqualisa until tomorrow now, so just out of interest wanted to see if anybody else has encountered these showers and if there are any common faults? Nigel Jones, Pgoblem that seems odd.
Aqualisa Quartz Shower Not Working – How to Fix It | eat more toast
The guarantee period on a processor when purchased with a complete shower is 5yrs. I suggest you concentarte your efforts on solving the cause and not the effect. When you turn the shower on and assuming some water is coming out, try leaving it on for a few seconds longer each time before switching it off.
Single outlet Thermostatic Mixer showers and Smart Pumped showers. Lift up the pump slightly and pull the mixer valve assembly away from the pump.
The Quartz has a pcb that does not like being shut off when its working like a computer There is not a lot you can do other than contact Aqualisa and get a new control board fitted each time it gets fried.
Depending on which model shower is currently installed and which shower is replacing it, there may need to be a couple of new fixing holes drilled in to the tiles but this is only on a small number of models.
Rang company who told me to turn it on and press boost which I did but didn’t help, worried how long to keep it running when water flow stops – should I do this or turn unit off R GMay 8, This could be caused by a blockage within the shower head or hose. Water may come out of the shower head in splurts if at all. When cleaning an Aqualisa product, we advise that you use warm soapy water or aqqualisa bathroom cleaning products. You could also test the data cable with a LAN tester to make sure that is good.
Keen to try this fix to hopefully save having to replace shower.
The open vent pipe is the pipe which rises from the top of the hot water cylinder and hangs over the cold water tank. However, and I may be wrong i’m not sure if there are any serviceable parts in the units.
Aqualisa Quartz Shower Not Working – How to Fix It
To remove the flexible hose you must hold this button down and unscrew the handset from the hose connection. This will reduce the pressure required to get water back through the system to the absolute minimum.
Would you know what I have to do to remedy this for good? Your name or email address: Now, it’s got power to the processor unit, however there doesn’t seem to be anything going on at the shower controls, which is joined aqualia the processor unit by a data cable.
Dripping Aqualisa shower repair | Simon Hart
In my case the shower had been working fine since it was new just over 10 years ago, but suddenly seemed to lose all power — water was getting through to the shower head but only came out in little more than a trickle despite that you could hear the pump working.
Use paper towel to clean the plastic valve assemblies, metal plates, rubber O-rings and spring loaded valves of any old grease and water.
We advise to allow working days for delivery.